![]() ![]() By doing this, you make it easier to feel that each screw has been started properly, and is not “cross-threaded”. After all the screws have been started, then go around and finish tightening all of them. OWC 480GB Aura Pro X2 SSD for MacBook Air (Mid 2013-2017), and MacBook Pro (Retina, Late 20) Computers (OWCS3DAPT4MB05) Features. When replacing the bottom cover, it is a good technique to insert and BEGIN tightening all ten screws BEFORE fully tightening any one screw. Don’t attempt to clean the Loctite from the screws - leave it in place, and it will continue to help prevent the re-inserted screws from working loose. This is to help prevent the screws from working loose and falling out. It’s important to put the two screws with no shoulder at the hinge of the cover.Īll ten screws require a P5 Pentalobe screwdriver, preferably with a magnetized tip to help hold and position the screw.Īll of the screws have blue “Loctite” thread locker compound on their threads. SAMSUNG 970 EVO Plus SSD 1TB, M.2 NVMe Interface Internal Solid State Hard Drive with V-NAND Technology for Gaming, Graphic Design, MZ-V7S1T0B/AM Western Digital 1TB WD Blue SN550 NVMe Internal SSD - Gen3 x4 PCIe 8Gb/s, M. Note that the eight 3mm screws have a shoulder under the head, while the two 2.3mm screws are “full thread”, i.e., there is no shoulder under their heads. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |